Direct Answer: If your furnace inducer runs and you hear clicking without burner ignition, the hot surface igniter is likely cracked. If the burners ignite and shut off within 3 to 5 seconds, the flame sensor is likely coated or failing. Call (815) 344-0496 for same-day dispatch.

What This Service Involves

Technicians measure resistance across the igniter, verify 120V supply from the control board, and test microamp DC current across the flame sensor rod before cleaning or replacing failed parts.

Common Warning Signs

  • No orange glow visible through the burner sight glass during startup
  • Burners ignite briefly then cut out after 3–5 seconds
  • Furnace enters a 1-hour soft lockout after 3 failed ignition tries
  • Visible hairline crack or white oxidation on the igniter element

Cost Factors & Local Considerations

Repair pricing depends on your furnace's age, brand-specific part availability (standard 80% AFUE vs. 90%+ condensing units), and whether dispatch is needed during standard daytime hours or overnight. Use our Crystal Lake Cost Calculator for a rough range before an independent technician provides an exact on-site quote.

Related Services & Areas

Compare both parts in our Igniter vs. Flame Sensor guide or explore gas furnace repair across Four Colonies and Crystal Lake Estates.

Need general help? Visit the Crystal Lake Furnace Repair homepage or our Furnace FAQ Hub.

Frequently Asked Questions

Often yes—light carbon buildup can be gently cleaned by a technician, though bent, cracked, or heavily pitted sensors should be replaced.

Thermal stress from thousands of heating cycles eventually makes silicon carbide or nitride elements brittle and prone to cracking.